The ITTF ban of VOC based speed glues for health reasons, has actually led to the (presumable) unintended restriction of routine table tennis glues as well. As an outcome, many maker have actually stopped producing all VOC based products, and are altering to water based glues. In the eye of numerous, these brand-new glues are harder to use, do not offer a few of the very same advantages and are considerably more pricey. The primary positive of the water based glue is that they are much safer to utilize, and although this is essential, careful handling of the VOC based glues likewise makes reasonably safe, so there is little reason to stop utilizing them best glue for rubber. This guide will describe to make VOC based table tennis glue from easily offered products, with efficiency very similar to the brand VOC based glues that are not produced. This guide is NOT a recommendation to continue using these glues, but it offers people the choice if they do want to continue using them.
A couple of cautions prior to we enter into this guide:
1. Under new ITTF rules, the VOC based glues are now prohibited to be used for ITTF occasions, and most national associations and clubs have actually adopted the same guidelines, and screening for these compounds may be done at some events. Although “airing” the bat after you’ve glued it up for a couple of days may well trigger all the VOC to vaporize, there is still a risk your bat may be found to be unlawful. So be warned!
2. ALL the VOC based table tennis glues contain unsafe and poisonous substances, so exposure to the glue or breathing in the vapours is a certain health hazard. Nevertheless these glues have actually been used for a number of years by players worldwide, so when handled with care in a well ventilated area, the threat is in fact quite low.
VOC based glues and the ITTF Ban:
Because the ban of all VOC based table tennis glues by the ITTF, a lot of producers have stopped producing them. The ban was truly focussed on VOC based “Speed Glue” (that most leading players utilize), as these produce a lot more vapours, and therefore posture a much higher health risk. Nevertheless because the ban, and the subsequent testing for VOCs to identify their presence, can not distinguish between speed glue and regular glue, both glues are efficiently banned.
Although there are rather a vast array of water based glues around, many feel they are as simple to utilize, nor are they as quick to use or as efficient. The VOC based glue actually provided rubbers a moderate type of priming, which actually enhance their performance a little, although not everyone discover this impact noticeable. This impact is more visible (and reliable) on tough sponged Chinese rubbers than it is on a lot of Euro/Japanese rubbers. Water based glues are also presently more pricey, although this is more likely due to the fact that they are a new product, and the rates are likely to calm down gradually.
Some rubber do have warning on them, and advise to ONLY utilized water based glue. The author of this short article has actually glued a lot of these rubber with VOC based glues as have some of his buddies and fellow players, and have never ever had a problem with them. Just speed glue is most likely to be a problem, as it stretches the rubber quite a bit. Still if you’re worried about voiding the warranty of a rubber, or are really concerned about harming the rubber, or the health problem is an issue, then you may be much better off with water based glue.